Skip the auto shop - Our mechanics make house calls

Q: Car only drives in reverse now

asked by on

Car wasn't going into drive gear but would go in gear 1, 2, 3 and reverse. Now it only goes in reverse. Whats my problem

My car has 155000 miles.
My car has an automatic transmission.

A: Hi, thanks for writing in. Most likely, the...

Hi, thanks for writing in. Most likely, the "forward apply band" has failed in your transmission. This failure will affect all forward gears as you are experiencing. This should be diagnosed by a reputable transmission shop who can confirm this diagnosis, and provide an estimate of repair cost. Hope this helps and best of luck!

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Save up to 30%

Get a quote

What others are asking

Q: Car won't start. Battery, starter & fuses ok. Suspect relay behind dash is there an easy way to access this relay?

The starter relay is located under the driver side speaker in the dash, mounted to the firewall. It may be possible to remove the speaker and reach the relay. If you are not comfortable with the repair or would like...

Q: Noise when I accelerate and turn right.

Hi there, It sounds like you have a failing constant velocity (CV) joint on one of the front axle shafts. When CV joints fail, they often make a loud clicking or grinding type noise, which could be interpreted as a...

Q: Hazard lights don't work, but the turn signals flash normally

The hazard and turn signals are controlled by the body control module on this vehicle. You will need to have the body control module circuits monitored by using a scanner that can access the body control module data stream to...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.