Q: Can a front end vehicle accident cause the crankshaft to stick?

asked by on November 02, 2016

i got into an accident where the radiator and ac conditioner had to be replaced and now the car says pops up a code P0015 is it possible the accident caused the issue?
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

How thermostat stuck open influences AC
Yes, because the computers control everything, and if the temperature isn't right, it can often make the AC not work right. What you will also find is that the system has electric cooling fans. If the car has a regular...
Display "Transmission Over Temp"
There are a lot issues with the connector between the starter and the totally integrated power module (TIPM) in the Jeep Commander. This can cause a host of issues including the transmission temp message and no starting. In some instances...
valve tick on driver's side - 1971 Dodge Charger
Hello. This is very normal for nearly every car. When your car's engine is cold and has been sitting for a while, the oil that is brought to the top of the motor when the engine is running will slowly...
Replace water pump
Hello. If your vehicle is leaking antifreeze, especially at the water pump, then I would stop driving the vehicle and get it repaired as soon as possible. An engine leaking at the water pump is likely to overheat quickly, which...
Battery keeps draining can it be a relay? 2007 GMC Sierra 1500
Hello - yes, it could be a stuck relay, or some other electrical component that is not shutting off when it should. To isolate the source of the battery drain, connect an ammeter (https://www.yourmechanic.com/article/the-best-tool-for-mechanics-to-diagnose-electrical-issues) to the positive (red) battery cable,...
My car shakes very bad whenever I'm accelerating or driving uphill...Could it be a motor mount or transmission issue?
Motor and transaxle mounts, or an engine operating condition such as misfiring, are likely causes. A fault in the transmission is a less likely cause of the shaking that you are describing. Motor mounts fail due to separation or tearing...
What does it mean that my rotors are glazed? Is there anything I should do?
Usually when someone says the rotors are glazed, they mean that the surface has acquired a high polish form long term use. Sometimes this might lead to brakes that screech when you are coming to a stop. If that is...
My car wont go above 40 mph,has a burning smell,and has a noise?
Hi There, What you are describing sounds like you may have a clogged catalytic converter. The catalytic converter converts toxic exhaust gases into less harmful pollutants that are suitable to be expelled into the atmosphere. When the catalytic converter is...
check engine light is on and gas light is flashing on my 1998 s420 mercedes Benz
Hi Jesse. Thanks for contacting us today. In most cases, a faulty gas cap or one that is not screwed on tight will cause the gas light and check engine light to illuminate. it's also possible that one of the...

Related articles

P2191 OBD-II Trouble Code: System Too Lean at Higher Load Bank 1
P2191 P2191 code definition System Too Lean at Higher Load Bank 1 What the P2191 code means P2191 is an OBD-II generic code for the engine control module (ECM) detecting that the fuel control has reached its rich limits when...
P0642 OBD-II Trouble Code: Sensor Reference Voltage “A” Circuit Low
P0642 means there is an abnormally low voltage reading within the "A" circuit often due too a faulty engine control module or other malfunctions.
P0358 OBD-II Trouble Code: Ignition Coil H Primary/Secondary Circuit Malfunction
Trouble code P0358 means the powertrain control module (PCM) has failed to receive a valid pulse signal from ignition coil H