The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
If you see the loose fuel cap warning shown in the vehicle information display, it usually means that the gas cap isn’t screwed down all the way. If the gas cap’s seal doesn’t lock in, the system will detect a...
It would've been helpful to know if the A/C was working fine or having a problem when the first belt broke. I suspect that the A/C pulley is binding, causing the second and first belt to break. If the A/C...
Hello there, thanks for your question. I believe you are correct in the fact that the starter is most likely your issue (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-starter). If all the lights, windows, radio, and wipers all function properly as they should, most likely the...
Assuming no air leaks and/or EGR system problems such as a stuck open valve (https://www.yourmechanic.com/services/exhaust-gas-recirculation-egr-valve-replacement), if your car won't start without spraying a volatile, flammable substance (starter fluid for example) into the intake, that means there is a problem with...
Hi there. The forward clutch and the reverse input clutch are slipping before engaging. This can be caused by the fluid being dirty, a dirty oil filter, broken input shaft seals, or sticking valves in the valve body (transmission brain)....
Hi there. It sounds like you may have either a blown fuse or a broken wire. Check and replace the fuses/relays as necessary. It may be necessary to check for battery voltage with a digital volt/ohm meter at the brake...
If I understand correctly, it sounds as though you're having difficulty starting your car and that you have read a code for the crank position sensor. A crank position sensor is a common failure in your car and can cause...
The reverse lights are controlled by the neutral safety switch on the transmission as a computer input to the front control and rear control modules. These modules are accessed by using a scanner to scan for codes and data input...
A misfire on a cylinder after you have replaced the plug, coil and injector can be caused by a cylinder problem like low compression or valve train problem or injector wiring or computer issue. You should have injector connector checked...
If If you have three or more kids, you could probably get by with a mid-size sedan if all you want to do is take them from Point A to Point B. Realistically, though, having kids means music lessons, athletics,...