The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
If you are in an emergency and unable to access your cell phone, you can use Uconnect, as long as your phone is paired with the Uconnect system. To use emergency assistance, press the Uconnect phone button, which is located...
Hi there. It depends on what type of digital scanner you're using, but most professional scanners will be able to see the misfiring cylinder on the scope while the engine is running. This will typically also indicate which electrical sensor...
When you had the water pump replaced (https://www.yourmechanic.com/services/water-pump-replacement) the surface on the engine block most likely did not have all the old gasket material removed. I would recommend having the water pump replaced and both surfaces cleaned thoroughly by a...
Hi there: The P0172 error code (https://www.yourmechanic.com/article/p0172-obd-ii-trouble-code-system-too-rich-bank-1-by-blake-griffin) indicates that there is too much gasoline being detected in the exhaust gases exiting the combustion chamber. The ECU uses a number of instruments, such as the mass air flow sensor (MAF), oxygen...
Most fluid that is used inside struts is going to be clear, light brown or a light green. The leak can be a residual leak from the strut seal and may not e a bad strut but normal leakage. If...
Hello - this issue suggests that either the engine/transmission wiring harness was damaged (https://www.yourmechanic.com/article/how-are-car-wires-protected-from-damage) when the bulkhead sleeve was replaced, or one of the engine/transmission CAN bus connectors is loose. The CAN bus is the major lelectrical signal connector between...
Hi there. Sounds like the transmission is slipping or a part is broken causing the vehicle to not drive. First check the fluid in the transmission and see if it's low. If the fluid is full and red in color,...
Hi there. The time to replace an ECM (Engine Control Module) on a 2011 Scion xB with a L4-2.4L engine is around 1 to 2 hours not including programming the ECM. ____________________________________________ Billing question was sent to CS for the...
The transmission is shifted using the shifter and connected to a cable to the transmission selector shaft then controls the transmission gear selection. If you cannot select a gear or vehicle rolls when in park then you need to have...
The The modern automotive HVAC system offers a number of different capabilities to help keep drivers and passengers comfortable during hot or cold weather. There’s the air conditioning system, the heater, and the vent system (which doesn’t use either the...
If If you’re in the market for a used Buick vehicle, you may want to check out cars under their certified pre-owned program. Many manufacturers have a certified pre-owned (CPO) program, and each one is set up differently. Read on...