Q: Amber engine light came on seemed to lose power. 2014 LR2 ,HSE 4 cyl turbo charged

asked by on October 08, 2017

Amber light came on experienced loss of power. Replaced battery last week. Think brake pads need to be replaced.

My car has 28500 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Catalytic converter replacement.
This would depend on the code that is retrieved from the check engine light. It never hurts to get a second opinion. I would recommend having another technician, such as one from YourMechanic, come to scan your vehicle for trouble...
Power steering pump whine and tough to turn when braking or going slow.
The most common problem for the whine noise is that the reservoir screen at the bottom of it gets clogged. When you turn the wheel, the pump needs more fluid, and cannot get it due to the clogged screen. There...
AC Blowing from vents and defrost
The air conditioner blend door is controlled by an electronic actuator and if the door is not in set position then you may have a defective actuator and need to replace it. The door operation should be in the manual...
Do i need a need a new gas cap/do i need an allignment?
Hello! Your question related to the gas cap suggests that you may have the incorrect gas cap installed on your car (if the original problem was in fact the gas cap). Unlike most vehicles in earlier years, these are generally...
What is the code P0406 and P0128?
The code P0406 (https://www.yourmechanic.com/article/p0406-obd-ii-trouble-code-exhaust-gas-recirculation-sensor-a-circuit-high-by-spencer-clayton) is for the electronic gas recirculation valve high circuit input. Meaning the valves sensor is detecting a high voltage input. This can be due to carbon build up on the valve, a bad valve, or a...
When I accelerate, loud ticking noise at low rpm, car jerks and stutters. It goes away at higher rpms.
The misfiring could be ignition or fuel related. If the plugs have not been replaced, on the timetable set forth in the maintenance schedule, that is certainly one possibly. Also, the plug wires could be tested. Diagnostic Trouble codes that...
What are the most common reasons my car won't start?
Be sure any engine immobilizer system (security system) is not activated, thus preventing the car from starting. "New" batteries are not necessarily fully charged when you buy them over the counter. Consequently, it has to be confirmed that the battery...
Can I exchange a 2001 transmission on a isuzu axiom in exchange for a different year or model isuzu
Hi there. On older vehicles, this type of transmission replacement option was rather simple; as long as it connected to the engine's flywheel and bolts were aligned. However, with new sensors and electrical harnesses, it becomes more difficult to complete...
What does it mean when the MIL stays on after car if shut off?
You may have a sticking EFI relay in the main fuse box in the engine compartment. This relay if stuck on can keep power to the computer to turn on check engine light. Replace the relay and then retest.

Related articles

P2328 OBD-II Trouble Code: Ignition Coil J Primary Control Circuit High
P2328 P2328 code definition Ignition Coil J Primary Control Circuit High What the P2328 code means P2328 is an OBD-II generic code for the Ignition Coil K Primary Control Circuit High to the Engine Control Module (ECM). This means the...
P0471 OBD-II Trouble Code: Exhaust Pressure Sensor Range/Performance
P0471 means the powertrain control module has detected an voltage that is out of the normal range due to the exhaust back pressure system.
P0973 OBD-II Trouble Code: Shift Solenoid A Control Circuit Low
P0973 means there is an error with the shift solenoid A control circuit due to a faulty solenoid, control circuit,or low or dirty transmission fluid.