Q: A.c. is knocking when turned on but I am not having any a.c. problems just the noise. Replaced it and nothing has changed

asked by on

A.c. is knocking when turned on but I am not having any a.c. problems just the noise. I changed out the actuator in the glove compartment but am.still having the same issue

My car has 156000 miles.
My car has an automatic transmission.

It sounds like you may have a damaged AC compressor or compressor clutch. As you may know the AC Clutch is the pulley that spins with the Belt. There are two ports on the rear of the Compressor. One is a Suction Port and the other is the Discharge Port. The Suction port is going to be your larger port and the Discharge port is going to be the smaller port. Refrigerant is sucked into the Suction port, compressed and then it exits out the Discharge Port, then entering the A/C Condenser. Your vehicle’s AC Clutch consists of the Hub, the Pulley, and the coil. The front part of the A/C Clutch is the Hub. Next is the pulley, which is where the belt rides. Finally, under the pulley is the coil, also called a field coil. The Coil is a copper would wire, that functions like a magnetic coil. If the AC Compressor is powered up, electricity engages the coil, and when this happens, it also engages the pulley. The large magnet forces the hub to pull against the pulley. Since the Shaft of the AC Compressor is mated with the A/C Hub, once engaged, it begins to pump refrigerant in the system. Turning whenever the engine is cranked, the A/C Compressor Clutch Pulley will spin even if the AC Compressor is off. If the A/C System is turned on, power is sent to your A/C Compressor Clutch and it will then engage. However, if the pressure in the system (or the refrigerant level) is either too low or high, switches will kill power to the Compressor to keep from damaging it. I would suggest having a professional from YourMechanic come to your location to take a look at your vehicle.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. A.c. is knocking when turned on but I am not having any a.c. problems just the noise. Replaced it and nothing has changed

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: I have an engine knock and my oil pressure guage is reading high, then stops shortly after starting to drive.

Hello, You may want to inspect your oil pump to see if it may not be causing the problem. If it is not pumping or circulating oil properly, it may also cause this type of increase in oil pressure that...

Q: Q: Transmission problems

Hello. It sounds like the clutch hydraulics have failed. These do not usually get replaced with the clutch unless there is a problem with them. Most of the time it is caused by a bad clutch master cylinder but it...

Q: Will driving your car with the Stabilitrak system off damage your car in any anyway.

Driving with the stabilitrac system off will not cause any harm to the vehicle, however you will lose the functionality of the traction control that the system is designed to offer. The traction control system monitors the steering and stability...

Related articles

P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.