Q: 99 accord will not start.

The ticking sound is caused by the valves in the engine experiencing a low oil condition, the lower the oil gets the louder the noise. This is a well-documented problem for this series where the vehicle will excessively consume oil,...

First we have to determine if the engine is cranking and not starting, or soley not cranking. Do you see the motor spinning (look at the drive belt) when someone is turning the key to “start”. If it is cranking...

I would suggest checking the flap vents inside your vehicle's air conditioning ducts. These vents open and close the direction of air flow. If the rear vents are working correctly, then it is likely not the A/C compressor or blower...

Hello. Thanks for writing in about your 2002 GMC Safari. There are several components that may be causing this problem. There could be a bad throttle position sensor (https://www.yourmechanic.com/services/throttle-position-sensor-replacement), a throttle cable (https://www.yourmechanic.com/services/throttle-control-cable-replacement) that is sticking, or a vacuum leak....

Hi there, thanks for writing in. This problem could rise from a variety of parts in the car, from the ABS system to the anti-theft system. I would recommend having one of our certified automotive technicians from YourMechanic come to...

This may very well be a faulty oil pressure sending unit. This is a sensor located down near the oil pan on your engine that monitors the oil pressure inside your motor. When this detects lower than normal oil pressure,...

Hi there. If only the high mounted light in the middle works, then there is a problem with the wiring to the rear lights. This is assuming that the bulbs are good. If the bulbs are fine then I usually...

Your vehicle may be experiencing engine misfires. Multiple misfires can cause the noise you are describing and if the misfires happen long enough, the check engine light will start to blink to warn of catalyst damage. Typical causes are the...

The clutch master cylinder is not relieving the pressure when applied. I recommend bleeding the clutch master cylinder and retest. If the condition continues, then replace the clutch master cylinder (https://www.yourmechanic.com/services/clutch-master-cylinder-replacement). If you need further assistance with your hose blowing...