Q: 1997 Eplorer 4.0 L transmission noise on gear down 1997 Ford Explorer

asked by on March 16, 2017

When slowing down gearbox makes noise

My car has 2280742 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

clutch sticks halfway after pressing down, cannot engage gears
Hello. It is important when discussing master and slave cylinders to make it clear you are talking about the clutch and not the brake system – there isn't a proportioning valve (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-proportioning-combination-valve) in the clutch system. Both have master cylinders...
Bad gas mileage
Hi there. The fuel mileage is never great in this car, but this is rather low. Most of the time if it is running fine and has recently dropped off it is because or a dirty air filter (https://www.yourmechanic.com/article/common-signs-of-a-dirty-air-filter) or...
Car won't start, 2012 Kia Rio
Hi there, thanks for writing in about your 2012 Kia Rio. If you only hear clicking, then you should have the starter checked to see if it is getting power. Replace the starter if there is power when you try...
Dashboard doesn't light up properly
Hello there, thanks for writing in. Sounds like you have a few things going on with your 1993 Porsche 968. If the rheostat is working properly, then there could be a few other faults. If just a few lights are...
Check Engine Light is on
Your check engine light may come on for many different reasons such as a faulty mass air flow sensor, a faulty O2 sensor, a bad catalytic converter, bad spark plugs or wires and many other reasons. Unfortunately due to the...
Lifter ticking and need specs and diagrams to replace the lifter.
Hi there. First you will need to drain all of the engine coolant from the engine. Then you will need to remove the intake, exhaust manifold to the side that has the lifter that is tapping, and make sure that...
Ignition timing out of sequence.
Hi there. First you would need to know the firing order for the electronics on the distributor. The distributor number one on the firing order is the terminal on the right side at the front of the vehicle. Since you...
I am trying to locate the electronic flasher module 2012 Ford Fusion
Hello - the flasher unit (turn signal/hazard warning flasher) itself is a blue plastic cube (golf ball size) located behind the the "knee panel" just to the left of the steering column. Visually identification is easy (bright blue). Should you...
My aftermarket crankshaft pulley is wobbling a little when it idles. Does it just need to be tightened, or replaced?
The harmonic balancer should not wobble at all. The heavy bolt that holds the balancer to the crankshaft snout is quite tight. Presumably the balancer bolt was torqued to the Factory Service Manual value, and so you cannot safely tighten...

Related articles

2012 Hyundai Elantra vs. 2012 Ford Focus: Which One Should I Buy?
The Hyundai Elantra and the Ford Focus are both offerings in the inexpensive compact sedan category, and both represent some of the best offerings in that class. Compact cars are slightly larger than a subcompact, but smaller than a mid-size;...
2011 Dodge Ram vs. 2011 Ford F-150: Which One Should I Buy?
Large trucks can be fun to drive, and even more fun to get dirty. Unfortunately, they may also cause you to get phone calls from friends who need to move into a new apartment. Fortunately, just having a truck may...
The Best Used Cars to Buy If You’re a Massage Therapist
If If you're a massage therapist, one of the cornerstones of your business has to be that you don’t keep your clients waiting. That means you need a vehicle that’s reliable. You also will have to move your gear, including...