Q: 96 Ford F150 with a 5.0 it's got a rebuilt motor and transmission I'm having problems with it firing a radically when it cranks
Everytime I start the vehicle it starts up fine and everything but what's going on is it's erratically firing it seems like a misfire but the plugs the wires distributor everything's brand new it's a completely just rebuilt motor I haven't tried replacing the mass airflow sensor or anything like that yet and was hoping that you would be able to give me a roundabout idea of what I need to look at thank you
My car has 120000 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Door handle broken
Hello. This is most likely a mechanical issue with one of the components of your door latch assembly. An inspection would need to be completed to determine why your door won't close all the way (https://www.yourmechanic.com/services/door-will-not-shut-inspection). I would suggest you...
Car shaking when accelerating
There are numerous potential causes for the symptoms you are experiencing. However, one thing that comes to mind is the torque converter. The torque converter clutch is usually applied at speeds above 30 mph when the transmission is in 2nd,...
My car loses power - is my fuel pump bad?
The fuel filter was a good first move, and it could be the fuel pump, but it could also be a pressure regulator, a problem in the air flow meter, or any part of the intake air system. There are...
My car has a rough idle and water leaking from the tailpipe - 1999 Toyota Land Cruiser
Hello and thank you for contacting YourMechanic. If the smoke is slightly white, it could be burning the fuel too cold. This is an issue with a cylinder misfiring and causing raw fuel to enter the exhaust pipe. Check all...
My front end is making a popping noise
This is a common sign of a failing CV joint. A CV (Constant Velocity) joint is a shaft that connects the transmission to the wheels, essentially transferring the power from the drive train directly to the wheels. The CV joint...
Why won't my car start the low oil light came on i drove it about ten miles added oil started it drove about 3 blocks and it died
Hi there: Depending on what type of car you own, there could be multiple reasons why your car won't start. If the oil light comes on, it typically indicates that you have low oil pressure as opposed to low oil...
My 1994 nisan maxima was running fine when it was parked 2 yrs ago now its missing I even put new plugs and wires on it still my
If the car has sat parked for 2 years with fuel left in the fuel rail and gas tank, be sure the fuel tank is thoroughly emptied BEFORE you add fresh gas. The injectors are probably plugged with varnish and...
My car has like a winding noise when driving if i turn the steering wheel left the noise goes away but then when i steer straight
Hi There, What you are describing sounds like a wheel bearing (https://www.yourmechanic.com/services/wheel-bearings-replacement) that may be starting to fail. If the sounds is more pronounced when turning specific ways, this indicates that it is usually the opposite wheel bearing of the...
I have a noise in engine when I accelerate I have 2011 Nissan Altima car
If you are getting a rattle in the engine when you accelerate it is an indication the engine is either running too lean on fuel or the ignition timing is not being controlled correct. This problem will require the computer...
Related articles
The Best Used Cars to Buy If You Live in the Country
Living Living in the country is a whole different way of living. You deal with rough and uneven roads, mud, snow, rain, and ice and you need a vehicle that can stand up to these kinds of conditions with ease....
P0446 OBD-II Trouble Code: Evaporative Emission Control System Vent Control Circuit Malfunction
P0446 code definition P0446 is an OBD2 diagnostic trouble code that indicates a fault within the evaporative emission control system. Other EVAP...
P2227 OBD-II Trouble Code: Barometric Pressure Circuit Range/Performance
P2227 trouble code definition Either the barometric pressure sensor is providing a reading that does not correspond to the parameters of the...
Browse other content
Cities
Services