Q: 96 Dodge halfton four by four .Rumble /vibration comes and goes just started two days ago .Caliper on passenger side is bad

The automatic locking feature keeps the seat belts pre-locked. This feature should be used anytime a child is riding in the seat. To engage and disengage the automatic locking mode. Buckle the seatbelt. Pull the shoulder portion of the seat...

Many of the latch parts inside the doors of modern cars are plastic to keep weight and cost down, and these plastic parts get brittle over years and break. Its very common for a small clip to break and disengage...

Hello. The rack and pinion typically will not cause this. It is either caused by a warped rotor, a failing bearing or a tire that is separating. Typically if it is the brake rotors it will only wobble when using...

An aftermarket keyless entry system (https://www.yourmechanic.com/article/how-to-purchase-a-remote-keyless-entry-system-for-cars-by-brady-klopfer) may or may not be required. If the vehicle is equipped with original equipment electronic door locks, the key fob typically should be able to be programmed to work with your keyless entry (https://www.yourmechanic.com/article/how-to-purchase-a-remote-keyless-entry-system-for-cars-by-brady-klopfer)....

Hi there. I can certainly understand and appreciate your concern. The highest priority on your list should be safety related items, followed by potential failures, then any maintenance. What I suggest you do is weigh the cost of the repairs...

Hi there. Most of the time, reduced engine power is caused by a restriction of fuel, or the throttle body's inability to efficiently mix air and fuel. This could be caused by a failing mass air flow sensor, EGR valve...

Hi there - as you suspect, a failed alternator, or serpentine belt (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-serpentine-drive-belt) (which drives the alternator) or its tensioner, could have failed and caused the behavior you are now seeing. Even a loose belt due to a weak tensioner...

If you just replaced the battery and still have no electrical power to anything on the vehicle I would first suggest you try and get a jump start to see if the battery you got is bad or low on...

Hi Charlie. Thanks for sending in your question today. In cases where multiple parts have been replaced, more often than not, the starting problem is due to something incredibly small but vital - such as a loose ground wire or...