Q: 2wd 93 suburban from start off quickly there's a jerk binding feeling I'm in rear end other then that she rides smooth any idea

To determine if a cracked mirror (https://www.yourmechanic.com/article/do-i-need-to-entirely-replace-a-cracked-mirror) needs to be completely replaced will depend on a few factors. Let's start with the interior mirror, or what is typically called the rear-view mirror (Https://www.yourmechanic.com/services/rearview-mirror-replacement). Generally this mirror is only replaceable as...

It is not advisable to drive your vehicle without the serpentine belt attached. Your vehicle has two serpentine belts listed. If the main belt is broken, the alternator and water pump will not be turning. You will lose all power...

This is most likely related to a fuel supply issue at start up. When you turn the key to on, your fuel pump is engaged and quickly (for a few seconds) primes the fuel system to get fuel to the...

Hello - coolant leaks (https://www.yourmechanic.com/question/coolant-leaking-from-engine-head-gasket) have many sources, sometimes very subtle to locate. Since coolant evaporates on a hot engine, it is often hard to trace to it's source. It is still possible you have a blown head gasket (early...

Hi there - while the basic engines have stayed relatively similar (3.3l or 3.8l), and the basic transmission is the same (41TE), engine and transmission management has changed considerably. Staying with the same engine (EGA/EGH) may work as long as...

Hello. This system works with several inputs including vehicle speed and the steering angle sensor. If you are not getting any power assist then the system needs to be scanned for codes and the inputs checked to see what is...

Hello, thank you for writing in. The catalytic converter (https://www.yourmechanic.com/services/catalytic-converter-replacement) is there to remove certain emissions like CO and NOx before your exhaust is pumped into the environment. While this is the practical and "environmentally responsible" thing to do, your...

Hi Linda. Thanks for contacting us today. When both the hazard lights and turn signal lights are not working, it's commonly due to a faulty or exposed wire. If the relay and fuse you replaced were both damaged, I would...

You will need to use a large pipe wrench to hold the shaft connected to the inner tie rod joint. Once you are holding with a pipe wrench then you can use a second large wrench to loosen the lock...