Q: 2008 Ford Edge - cost of changing the input and output sensors on the transmission changing fluid and replacing both axles?

Your car is equipped with both front and rear defrosters. While the front defroster is controlled with the fan speed/blower knob and ties into your air conditioner, the rear defroster is different. Here’s how to work it: Locate the Rear...

You can flash the high beams to get someone’s attention, or to alert other drivers. To do so pull the turn signal lever towards you, and then release it. The high beams will flash on and then off, and the...

Hello. A few things I would check on the vehicle are the struts, the axles, the control arm bushings, the ball joints. I would carefully examine the whole front end suspension for any worn or damaged components. You will probably...

Hi there. The problem with most shaking and vibration issues is that one damaged component like broken motor mounts can mask other parts that may be damaged. A cracked exhaust manifold (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-exhaust-manifold) is one of those that can cause the...

Hi there: When it comes to front end suspension 'noises', a few things instantly come to mind, ranging from wheel bearings that are slowly wearing out (which progressively get louder as you've described), to brake rotors that are warped, brake...

The best way to determine if you have worn internal engine parts is to use a micrometer and plastigauge if necessary to take measurements of certain parts. Once these measurements have been taken, you will then want to compare them...

Noise of that type is often due to a failed or failing bearing in one of the pulleys or accessories (e.g., alternator, water pump, A/C compressor) that is driven by the serpentine belt, the belt is not properly tensioned, or...

Hi Bill. Thanks for contacting us today. i've forwarded your question to our service and sales department to determine whether or not one of our mobile mechanics in your area would be able to complete this job for you. Typically...

When the transmission fluid is colder it may be sealing good and as fluid warms the internal transmission leaks by internal seals. Have transmission pressure tested for internal leakage and may need overhaul.