Q: 2004 kia sedona keeps overheating

If you purchased your car new, there are a few driving strategies that you should employ to help break your car in: For the first 200 miles of driving, you should try to avoid hard stops. For the first 500...

Hello! One general giveaway of a bad CV axle is a clicking sound when turning. CV axles are vital to the stability of the vehicle and they transfer the power to the wheels to make them turn. Noisy CV axles...

The engine may be getting hotter from the CVT transmission overheating which causes the engine coolant to get hotter than it should. The manufacture has a technical service bulletin to add a transmission external cooler and clean out the cooler...

The headlights on this vehicle are controlled by a multiplex integrated control unit (MICU) located under the left side of the dash on fuse panel. The MICU contains all the headlight controls inside as an assembly and the low beam...

The starting (https://www.yourmechanic.com/services/car-is-not-starting-inspection) issues scream timing. The typical causes that set these codes are the cam (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement) and crank position sensors (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement). The only option you have not tried to my knowledge is the camshaft position sensor. I would start...

The push button panel for your climate control is also the control unit. It uses the signals from various temp sensors to decide what to tell the climate control what to do. It also decides on the fan speed and...

As you may know, the distributor has a small gear on the bottom end of it that turns with the flywheel as the motor turns over. If the motor turns over and the distributor does not turn, this would suggest...

I found an article on a Honda dealers website on how to program the different features for the automatic door lock features. There is no way for me to know whether your vehicle is equipped with the automatic locking features...

Hello, thank you for writing in. The first step is to make sure all battery cable and alternator connections, are clean, dry, and tight. The second test is to have the vehicle scanned for diagnostic codes, in case there is...