Q: 2002 dodge Dakota head & tail lights won't come on

Hello, having damaged wiring can cause all kinds of issues, the only proper way to repair wiring is to cut off the damaged portion, strip the wiring, then solder the wiring together and use wiring shrink tubing to cover up...

Hi. When air comes out of the vents at uneven temperatures, the blend door actuator is usually at fault. Either debris buildup is blocking the door from moving or the electronic actuator on the door itself is malfunctioning. A technician...

If these two codes keep coming up together, it sounds like there is probably a spot in the wiring harness that is shorting to ground. P1292 is for an injector and the P0181 (https://www.yourmechanic.com/article/p0181-obd-ii-trouble-code-fuel-temperature-sensor-a-circuit-range-performance-by-jay) is for a fuel temperature sensor,...

Hi. Most likely there is something out of alignment in your pulley system causing the belt to come off. The first thing to inspect would be the idler pulley (https://www.yourmechanic.com/services/idler-pulley-replacement). Remove the belt and check if the pulley wobbles. If...

Hello - the P0420 and the inconsistent waveform for the post-cat O2 sensor might be related to your failing intake manifold gasket issue. If tiny droplets of coolant are being sucked into the engine - one failure mode for this...

The distributor on the 1996 Accord has an integrated Cylinder Position (CYP) Sensor, Crankshaft Position Sensor (CKP) and Top Dead Center (TDC) Sensor. If you have replaced the distributor due to diagnostic trouble code P1382 setting, which involves faults with...

Hi There, If you drive for a period of time without coolant in the vehicle, this could have potentially caused damage to the motor resulting in a damaged cylinder head gasket which may cause the car to overheat (https://www.yourmechanic.com/services/car-is-overheating-inspection) intermittently,...

Hi Ryan. In most cases, the type of sound you're talking about is caused by a loose serpentine or drive belt. It could also be due to a pulley that is wearing out or even loose bearings inside the AC...

The starter and/or solenoid may be faulty. Starters sometimes develop "bad spots" on the armature (of the starter motor). That causes intermittent, unreliable operation just like what you are experiencing. The problem is easily diagnosed and the solution can be...