Q: 1999 Jeep Cherokee idles fine, loss of power at higher rpm. Cruise control stopped working at the same time. Stalls at stopped when revved up from idle.
1999 Jeep Cherokee idles fine, loss of power at higher rpm. Cruise control stopped working at same time. Stalls when revved to higher rpm at stop from idle. Vacuum leak?
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Car not moving when accelerating
Hello! There are a few things that could be going on. You didn't state whether or not there is any noise when the gas is pressed, which could narrow down the root of your problem. The most common cause of...
Sunroof is leaking
This is a common issue on your vehicle. There are two places that the sunroofs leak from. One is the rubber seal around the glass. Another is the drain tubes that run from the sunroof gutters down to the doorframes....
Car speakers going in and out
The radio is likely the cause, but the speakers may also be the cause. If the speaker sounds good one minute, then bad the next, then it is the radio. I recommend that you have a mechanic, such as one...
Interior door handle not working
Hi there. Your door handle is connected to a linkage which will disengage the door latch letting you out of the vehicle. If your vehicle's linkage inside of the door panel is broken it will not disengage the locking mechanism....
Carburetor needs tuning
The fuel accelerator pump is most likely bad and not pumping extra fuel during acceleration. The carburetor needs to be replaced (https://www.yourmechanic.com/services/carburetor-replacement) or overhauled if you can find a mechanic with the experience to overhaul carburetors. I recommend having a...
Car shakes and jerks
Hi there, when you say jerking do you mean a vibration or changing in speed? If the car changes in speed, then you should make sure your fuel pressure is okay. Other Impala owners have reported a shaking at startup...
Why when I install a starter in truck it makes a lot of noise an then have to replace starter again the gears are grinded down
You may need to install a spacer to prevent the flywheel from touching the starter gear when the vehicle is running. This could be cause of both the noise and the worn down gears. If you need help with this...
Brake Pedal feels loose have to push all the way down pumping it helps stop it but mostly it keeps sliding until I pull E-brake.
Hello. After replacing any brake hose or line, the brake system has to be bled of any air. Did your friend do that after installing the hose? Try bleeding the entire brake system. If the seal under the brake fluid...
What do you think could be wrong?
Hi there: What you're describing appears to be a problem with the serpentine belt (https://www.yourmechanic.com/services/serpentine-drive-belt-replacement); which powers many of your vehicle's components including the alternator, power steering, and air conditioning systems. When the belt or the pulley's that turn the...
Related articles
Symptoms of a Bad or Failing Cruise Control Clutch Release Switch
If you have a manual car, common signs include a cruise control system that cuts off on its own or does not cut off when the clutch pedal is pressed.
Symptoms of a Bad or Failing Accelerator Cable
Common signs include damage to the outer covering, delayed accelerator response time, and problems with cruise control.
How Long Does an Idler Pulley Last?
The The drive belt that is on a car runs nearly all of the major components of the engine. Most of the newer cars on the market have a serpentine belt rather than various V-belts. In order for this belt...
Browse other content
Estimates
Maintenance