Q: 1997 s10 pick up 4.3 vortex ran out of gas Pitbull Back In It Now does not want to start

When deciding to replace your spark plug wires (https://www.yourmechanic.com/question/when-should-spark-plug-wires-be-replaced), you should first check your owner's manual. Follow the recommended maintenance schedule (https://www.yourmechanic.com/scheduled-maintenance) that the vehicle manufacturer has published. Besides regular maintenance, another reason to change your plug wires is due...

Hi. If fuel is leaking from your vehicle, I would recommend you stop driving the vehicle immediately, and have it serviced as soon as possible. Gasoline is highly flammable, and driving a vehicle that is leaking gasoline is very unsafe....

Hi there. The problem could be that your valve stem seals are leaking oil into the cylinders when the car is off. Once you start the car, the engine burns the excess oil that is in the cylinders. This issue...

It sounds like the engine thermostat, a device that reduces coolant flow until the engine has reached it's operating temperature, is not opening. This prevents hot coolant from getting to the the radiator where it is cooled. If the dealer...

Hello. It sounds like you may be having an issue with one of your outer tie rods. The outer tie rods connect the power steering system to the wheels. These tie rods are ball joints but they are not the...

Hello. It does sound like there are a lot of issues going on with the vehicle. Before making such a hard decision I would really get a complete diagnostic of what is going on with the car. It may not...

Overheating can be caused by a number of things such as low coolant levels, a faulty thermostat (https://www.yourmechanic.com/services/thermostat-replacement), a clogged radiator (https://www.yourmechanic.com/services/radiator-replacement) or a failing coolant fan switch. As you may know the coolant fan switch (https://www.yourmechanic.com/services/cooling-fan-relay-replacement) helps to maintain...

If the bulb filaments are intact and the terminal contact is good, you should check for power to the terminals of the bulb socket. If there is no power, it is a simple matter of tracing the circuit back to...

Hi Andrew. Thanks for sending your question today. Typically this Toyota-specific OBD-II trouble code is due to an internal leak in the actuator circuit and the accumulator circuit. The first step in diagnosing this problem is verifying that there are...