Q: 01 camry put New starter in alt good 12v bat read 14.8v car starts on cold engine when car is warmed up and driven only clicks

Hello, having a convenience feature not working properly can be annoying, especially when it has to do with the entertainment system. It appears that Mazda has recognized this issue in Technical Service Bulletin (TSB 09-008/15) to resolve issues with the...

The power steering pump, or high pressure hose may be leaking. If the temperature is cold outside, the fluid may thicken and cause a failure of the hose, or pump, or both. If this is the case, the fluid should...

Hi there. Most of the time, this is caused by a dirty throttle body (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-throttle-body). If there is build up in the throttle body bore, then the throttle plate will have trouble racing the correct location keeping the engine from...

Hello. A no start condition can be caused by a wide variety of things. If the battery, fuel pump, and starter have been replaced then they are likely not the source of the issue. Aside from a bad fuel pump,...

Hi there. When I get these readings during an emissions test I usually start by checking the fuel pressure. A lean running condition from a weak fuel pump (https://www.yourmechanic.com/services/fuel-pump-replacement) will cause this. If the fuel pump is fine, then I...

Hi there. It is not common for an air bag deployment to cause any damage outside of the vehicle; in fact, it's virtually impossible. It is highly probable that these two issues are non-related.

The check engine light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) indicates that there is likely something wrong with the engine or transmission in your vehicle and will usually come on in conjunction with the vehicle going into the reduced power mode (https://www.yourmechanic.com/services/reduced-power-light-is-on-inspection). This happens when...

You can drive the car normally and get it repaired at your earliest convenience. The trouble code that you are referring to, P0141, typically means that the heater element in an oxygen sensor is not functioning or the circuit to...

Check with the dealer to be sure the vehicle ECM has the latest software calibration from Toyota. Check for any stored trouble codes. If the problem is intermittent (and not resolved by any applicable software updates), typically that means there...