Jeep DJ3 Engine is misfiring Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(21)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(21)

Engine is misfiring Inspection Service

How much does a Engine is misfiring Inspection cost?

On average, the cost for a Jeep DJ3 Engine is misfiring Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1963 Jeep DJ3L4-3.2L DieselService typeEngine is misfiring InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1965 Jeep DJ3L4-3.2L DieselService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1963 Jeep DJ3L4-2.2LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1964 Jeep DJ3L4-2.2LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1960 Jeep DJ3L4-2.2LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1966 Jeep DJ3L4-3.2L DieselService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1966 Jeep DJ3L4-2.2LService typeEngine is misfiring InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1965 Jeep DJ3L4-2.2LService typeEngine is misfiring InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Jeep DJ3 Engine is misfiring Inspection prices

When an engines misfires, it’s usually readily apparent to the driver from the stuttering and jerking produced by the engine when one or more cylinders fails to fire properly, either because of ignition- or fuel-related issues. It is accompanied by a loss of power in direct proportion to the severity of the misfire.

It can be tricky for to track down the problem if the misfire only occurs under certain circumstances, for example, under load. Not all misfires occur across the operating spectrum.

For older vehicles:

On older, carbureted vehicles, the culprit will almost certainly be in the ignition system as older vehicles lack many of the sophisticated sensors that can cause a misfire. A vacuum leak or a faulty fuel pump can also cause this symptom as well. The first thing the mechanic will do is determine which cylinder or cylinders is misfiring, and the spark plug color is probably the best way to tell. The guilty plug will most likely be grayer than the others, which should tend toward brown coloring. If needed, the spark plug can be replaced.

The next step would be checking the wiring to that plug for cracks and deterioration, and replace as necessary.

For most modern vehicles:

In modern cars, misfiring will invariably be accompanied by a Check Engine light. In fact, checking for efficient combustion was the primary reason the U.S. government introduced the rules for OBD-II (on-board diagnostics, second generation). It was part of the push toward cleaner exhaust emissions.

A code reader will tell you which cylinder is to blame, but it may not say whether it is a problem relating to the injector serving that cylinder or the systems delivering the ignition spark. As with older vehicles, a look at the wires and spark plugs is a good idea. Checking them in the dark will sometimes reveal errant spark tracking, as will spraying them with a fine water mist.

One way mechanics check which spark plug is failing to hold its own is by running the engine at an idle speed high enough to produce the misfire, then removing leads from the coilpack (the unit that looks like the distributor we are used to seeing in older vehicles ) one by one. Most removals will cause a profound change in idling performance, but a defective wire will not. That will suggest that it’s either the spark plug or the coil serving that cylinder at fault. If a new spark plug at that cylinder does not remove the stumble, the mechanic may need to replace the coil pack or the wires as a set.

If it isn’t an ignition issue, then the injectors will need to be checked. A mechanic uses a multimeter to check the resistance value at each injector. It may be a bit difficult to reach them, sometimes requiring the removal of an engine cover and the intake manifold. The mechanic disconnects the injector, then touches the multimeter probes to the two connector prongs to read the value, in Ohms. If any of the injectors read outside of the specified values, they will need to be replaced.

Along the same lines, a fuel pump starting to go bad can also cause misfires or similar issues and can be diagnosed with a fuel pressure check of the entire system with the appropriate equipment. This should only be done by a qualified mechanic as the fuel system is highly pressurized and of course, fuel is flammable.

Common reasons for this to happen:

  • Faulty spark plugs or wires
  • Faulty ignition coil
  • Broken piston rings
  • Burnt or bent valves
  • Broken valve springs
  • Camshaft worn out
  • Fuel injector is not working

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the misfiring engine, and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How important is this service?

A misfiring engine is accompanied by a loss of power, which makes this issue a critical one to correct promptly. Book a mechanic to perform a thorough inspection as soon as possible.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Jeep mechanics

Real customer reviews from Jeep owners like you.

Excellent Rating

(21)

Rating Summary
19
2
0
0
0
19
2
0
0
0

Daniel

9 years of experience
46 reviews
Daniel
9 years of experience
Jeep Grand Cherokee V6-3.7L - Engine is misfiring - Fort Lauderdale, Florida
Great overall experience, Daniel was able to properly diagnose the issue with my jeep. Ill definitely recommend your mechanic to all my friends.

Dwayne

20 years of experience
9 reviews
Dwayne
20 years of experience
Jeep Liberty L4-2.8L Turbo Diesel - Engine is misfiring - Delray Beach, Florida
Dwayne answered all of my questions and is extremely well versed as a mechanic.

Jay

37 years of experience
967 reviews
Jay
37 years of experience
Jeep CJ7 L6-4.2L - Engine is misfiring - Riverside, California
Great guy, very knowledgeable.

Attila

19 years of experience
948 reviews
Attila
19 years of experience
Jeep Grand Cherokee V6-3.7L - Engine is misfiring - Linden, New Jersey
Great service and very knowledgeable.

Excellent Rating

(21)

Rating Summary
19
2
0
0
0
19
2
0
0
0
Number of Jeep Engine is misfiring Inspection services completed
231+
services done by our mechanics
TOTAL NUMBER OF EXPERT Jeep MECHANICS
1300+
experts on our platform

Recent articles & questions

How to Get a Car Insurance Quote
Car insurance is one of the most important aspects of owning a vehicle. An insurance policy helps protect you in case you get in an accident (https://www.yourmechanic.com/article/how-to-survive-a-car-collision-by-joyce-morse), or in case your vehicle is damaged when you are not in it....
How to Get Smog Technician Certified in Illinois
Automotive technician jobs include smog certified emissions inspectors. In Illinois, you apply and train directly with Applus to become an inspector.
P0974 OBD-II Trouble Code: Shift Solenoid A Control Circuit High
P0974 means there is an abnormal voltage reading regarding the shift solenoid A control circuit, likely due to fluid issues or faulty wiring.

Lights come on and clicking behind steering wheel

It sounds like you may have an electrical short somewhere within your steering column. This may be related to wiring, the clock spring, or even fusebox issues (https://www.yourmechanic.com/services/fuse-box-replacement). The fusebox is usually located under the driver side kick panel on...

Will turn over but won't start - 1968 Chevrolet C10 Pickup

Hello. You need to see if you have power to one side of the coil and blinking power on the other side when you crank the engine. If you do and no spark comes out of the coil, then replace...

My coolant is going down really slowly

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com