BMW 533i Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(15)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(15)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a BMW 533i Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1984 BMW 533iL6-3.2LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
1983 BMW 533iL6-3.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
Show example BMW 533i Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert BMW mechanics

Real customer reviews from BMW owners like you.

Excellent Rating

(15)

Rating Summary
12
1
0
0
2
12
1
0
0
2

Chris

20 years of experience
448 reviews
Chris
20 years of experience
BMW 533i L6-3.2L - Pre-purchase Car Inspection - Portland, Oregon
Was prompt, detailed, provided an extensive report, was responsive to questions, and spent a great deal of time with vehicle. Also, immediately provided quote for immediate repair. Highly recommend.

Chris

20 years of experience
448 reviews
Chris
20 years of experience
BMW 533i L6-3.2L - Valve Cover Gasket - Portland, Oregon
Showed up on time, responded to questions asap, repaired items and diagnosed issues (providing context and severity about them) quickly.

Michael

36 years of experience
74 reviews
Michael
36 years of experience
BMW 525i L6-2.5L - Car starts and then dies - San Antonio, Texas
I was very impressed by his knowledge!!! He explained to me what my problem was and i told him that I would keep him at the top of my mechanic list!!! Thanks Your Mechanic!!!!

Brian

23 years of experience
681 reviews
Brian
23 years of experience
BMW 740i V8-4.4L - Car starts and then dies - Jacksonville, Florida
Outstanding performance knowledgeable, friendly, polite made sure that i was completely satisfied with his work thanks bryan.

Excellent Rating

(15)

Rating Summary
12
1
0
0
2
12
1
0
0
2
Number of BMW Car starts and then dies Inspection services completed
165+
services done by our mechanics
TOTAL NUMBER OF EXPERT BMW MECHANICS
1100+
experts on our platform

Recent articles & questions

How Long Does a Dome Light Bulb Last?
The The dome light bulb is located on the ceiling of your vehicle and is also called the courtesy light. It normally turns on and off when you enter and exit the vehicle. This automatic switch can be turned off...
The Guide to Legal Car Modifications in Idaho
ARENA Creative / Shutterstock.com Whether you live in the state or are planning to move there, Idaho has regulations that cover vehicle modifications that you must follow to ensure that your vehicle is considered street legal when...
How to Adjust Drive Belts
Drive belts power electrical systems and other features in your car. An improperly adjusted drive belt can cause damage to your engine.

Problems starting my car

Hi. Usually a high pitched noise would narrow the diagnosis down to either a pulley issue or belt issue. I recommend having a certified mechanic, such as one from YourMechanic, listen to the noise (https://www.yourmechanic.com/services/loud-screeching-noise-when-i-start-the-car-inspection) to see why your car...

White smoke coming out my exhaust.

Hi there. The problem could be that your valve stem seals are leaking oil into the cylinders when the car is off. Once you start the car, the engine burns the excess oil that is in the cylinders. This issue...

Car does not move when clutch is released

Hi There, It sounds like you may have a worn out clutch disk that is causing the clutch to slip entirely when you release the clutch pedal. The clutch transmits engine power to a gearbox, and allows the transmission to...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (855) 347-2779 · hi@yourmechanic.com