1. Home
  2. Advice
  3. Tags
  4. CC

Showing articles & questions for topic
CC

Related articles

A Buyer's Guide to the 2012 Volkswagen CC
At some point, most of us have to choose between the cars we wanted when were kids and the ones we need for our commute to the office or to pick up our...

Related questions

Question
Car keeps needing to be jump started after sitting for a day or two
Pep boys is probably right about there being a drain, but they may not have the know-how or equipment to detect it. Chances are your CAN (control area network) is not 'going to sleep." The can is the line of...
Question
I have a 2012 cc with a p0016 code no start. chain is tight and all turns freely when turned by hand
Code P0016 broadly means that the PCM has detected that the Crankshaft and Camshaft are out of sync. If they are out of sync beyond a specific, threshold number of degrees, the car simply won't start. The cause of that...
Question
Are the 2010 vw cc sport expensive to repair
It has been a long time since a Volkswagen has been an economy car. It is less expensive to maintain than a Mercedes, BMW or a Volvo. but will be more expensive than similar Japanese models. Especially the turbo models....
Question
Car wont start 2011 VW CC
Hello - first task is to extract the problem code(s). There is a problem with the the engine/transmission setting the "Check Engine" (the wrench symbol), but only the codes will guide you to what specific problem needs attention. Given the...
Question
Was driving on the expressway and my car started shaking, check engine light turned on, oil light turned on and off
Hello, thank you for writing in. Shaking and vibrating typically comes from a misfire, or poor engine performance. A lack of oil will absolutely contribute to these symptoms and amplify them, if not cause them to begin with. You want...
Question
Could a bad ignition coil cause a lack of heat when turning on the heater?
The ignition coil generally does not have anything to do with the engine's ability to produce heat when the engine is running properly. The lack of heat you are experiencing may be a result of a clogged heater core. The...
Question
Wheres the crankshaft sensor located on a 2010 vw cc 2.0
Hi There, The crankshaft position sensor on your vehicle should be located behind the timing chain cover. In order to get to it, you will need to remove the top plastic cover and then the timing cover itself. It should...
Question
how a code p2181 but the temp is normal
Hi there. The code, P2181, stands for Cooling System Performance. This code is meant to give a certified mechanic a starting point to begin their investigation for car problems. In most cases, the code is triggered due to either overheating...
Question
I just bought a used 2011 VW cc 2.0 and I am having problems the EPC and motor light keeps coming on 2011 VW CC
Hello - the Electronic Power Control (EPC) light is a catch-all of sorts, representing some problem (engine, transmission, wheel speed management - incl. brakes, etc.) that could affect the ability to control power to any wheel on the vehicle. The...
Question
Where is the crankshaft sensor on a 2011 vw cc sport 2.0
The crankshaft sensor is in center of motor near flywheel even with starter on engine block.
Question
My car battery keeps dying after a few days of be fully charged my alternator is good what can be the problem?
Hi there. On most cars, trucks and SUV's sold in the US, the battery is used to engage the starter and power accessory components while the engine is not currently running. Due to this fact, if any accessory is left...
Question
VW CC 2010 Sport has pressur fuel too low code. How much is it to replace high pressure fuel pump
Hi There, It sounds like you may have a fuel supply problem in getting the proper amount of fuel to the fuel injectors. As you know, when you turn the key to on, the fuel pump is activated and the...
Question
where is crankshaft position sensor located on 2012 vw cc 2.0
The crankshaft sensor is located near rear of motor on the left rear side of the engine.
Question
can't find crank sensor on VW CC 2010... any ideas?
The crankshaft sensor is on the side of the motor near transmission directly in line with the starter on side of engine block.
Question
Will a bad crankshaft position sensor cause my car to turn off while at a stop light?
Hi there. The issue could be one of the following. Check The fuel pressure could be low or dropping when the engine is stalling out - possible fuel pump failure The crankshaft position sensor could be shorting out or...
Question
I have been using 20W40 engine oil out of ignorant for two years now on my Passat cc But I found out that the right oil is 5W30 or
Hi Justin. Thanks for taking time to contact us today. First off - don't worry, you're not the first person to make this common error. Although higher viscosity engine oil is not always the best way to protect an engine,...
Question
So I am trying to change my spark plugs in my 2012 Volkswagen CC. But autozone gave me the wrong size. Unknowingly I put them down
You need to check to see if you are using the correct socket for the spark plug since some use a 9/16 socket instead of the 5/8 socket so you can get out the plugs. If you still cannot get...
Question
2009 VW CC won't crank, lights all work do not dim, windows ok, battery is good. No clicking sound. Horn does not beep when locked
The most likely cause of this issue would be the starter motor. Oftentimes the starter motor can fail I'm not cause a clicking sound when the vehicle is being attempted to start. I would recommend having a car will not...
Question
There is a small brown sludge oil layer in my coolant tank.
Often times, sludge in the radiator is an indicator of a leaking cylinder head gasket, which can lead to major engine damage if not checked out soon. A blown head gasket may cause a number of different symptoms. A head...
Question
where is crankshaft position sensor located on 2011 vw cc r-line
The crankshaft position sensor is typically mounted to the right of the oil filter on this engine model. Usually, the oil filter has to be removed to gain access. The camshaft position sensor should only be changed if it fails...

Need a mechanic?

Our certified mobile mechanics make house calls in over 700 U.S. cities. Fast, free online quotes for your car repair.

Get a quote

Post a question and get free advice from our certified mechanics.


Ask a question