Q: What does the Intelligent Key detection Warning Light mean?

If someone has already diagnosed that the catalytic converter is faulty on your vehicle and you know they are correct, that is the cause of your check engine light. Your oxygen sensors pick up more fuel in the exhaust when...

Hello. It is common to lose a small amount of air over time. Usually about a pound or two of pressure a month is normal. If it is leaking faster than that then it amy have something stuck in the...

I think you are correct - the transmission is in "limp" mode. Have a professional mechanic check for problem codes to indicate what the fault might be. This is an important "next step" because that problem may not be with...

If the timing belt isn't moving, it is either broken or the teeth have stripped off at the crankshaft pulley. A broken timing belt will usually show signs of fraying at the camshaft sprocket. If the teeth stripped at the...

Hi there. The codes p0300 (https://www.yourmechanic.com/article/p0300-obd-ii-trouble-code-random-multiple-cylinder-misfire-detected-by-jamahl-walker) and p0303 (https://www.yourmechanic.com/article/p0303-obd-ii-trouble-code-cylinder-3-misfire-detected-by-spencer-clayton_2) are for the engine having a misfire. P0300 is for a random misfire where p0303 says that cylinder 3 had a misfire all the time. The code p1314 (http://obdii.pro/en/code/P1313) means that...

What you are describing is negative camber. Many vehicles have slight negative camber to promote stability on turns but the amount is minimal, perhaps 0.50 to 1 degree. If the negative camber on your vehicle exceeds the factory specification, typically...

Hello -both the flasher unit (https://www.yourmechanic.com/article/how-to-replace-a-turn-signal-hazard-flasher-by-jessica-howe) and the relay for it are close to each other, and under the dash just left of the steering column. The knee crash pad will need to be removed to make it easier to...

It's "possible" but if the oxygen sensor(s) were bad enough to cause such symptoms, the check engine light would be on and there would be a diagnostic trouble code referencing an oxygen sensor or sensor circuit fault. In any event,...

Hello, thank you for writing in. Automatic transmissions work primarily off of solenoids that control hydraulic fluid pressures in the transmission, which then control what gear you are in. You should start by checking the level of the transmission fluid,...